Skip to content

Lights, Strobes, and Lighting Technique / Archived topic

Need Advice on Slave or wired two strobe setups

Started by Photobeat ·

  • 5Posts
  • 5Replies

Read-only discussion

Need Advice on Slave or wired two strobe setups

5 posts
  1. Assuming you do not have TTL on your rig I was wondering if anyone really tested the difference on having the second strobe wired vs. just using slave flash for the second from the wired first strobe.

  2. Hello Stephen

     

    I often used my second Sb-105 in slave manual mode.

     

    usually this would be in the macro situation as there is 100% certainty that it will behave as it should.

     

    i've recently done a little testing on my new 12-24mm zoomer, this was carried out in using 1x Sb-105 wired the other slaved on 8-4 tlc arms & all worked well

     

    take a look. simple pool test of myself holding the camera at me.

     

    post-4127-1139594307_thumb.jpg

     

    the strobes were tested in lots of different position and worked 100% of the time.

     

    However , i must say that this was in a indoor pool that is quite dark, and that the camera is approx 1.5ft away from me.

     

    I've completed some testing a long time ago using a pair of Ys90 Duo in a typical WA situation with blue water around and it was HIT & MISS as the reflectance is very low to trigger the slave.

     

    Personally i always DUAL cable my SB-105's if shoot blue water WA shots, If i know i might have to disconnect a strobe underwater to say BACK LIGHT a subject with a strobe in a cave or similar, then i'll wire up with a single cord.

     

    hope this helped a little

     

    regards

     

    Craig

    Edited by craig nelson
  3. Thanks - I appreciate it - I wanted the option to disconnect and backlight - I think I would if it was 100% of the time but for sure reliability I guess the second cord is the way to go. Hope to see more responses thanks for yours.

  4. I often use a slave strobe for macro, where it fires about 99%.

     

    Wide angle, not so much. It seems to fire maybe 30%. This is using the slave built into the strobe, however, not a separate slave controller.

     

    It is handy for disconnect oddball slave placement...if I'm entering the water anticipating this (WA), I'll take a third strobe in a pocket, and have the other two wired.

     

    All the best, James

  5. A solution for WA with slave can be Colin's suggestion with the fiber optic cable, that mention few thread down here.

WaterPixels Store

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.