my strobe vill not fire

hi

whats is wrong my inon strobe vill not fire

have running som test att home am using

ikelite synk cord for inon strob

how do a st the internal camera flash?????

on the test a have don is S or A mode but

the number on lcd flash all the time??????

need som help

kent

olympus e410

inon 240 strobe

Does the Inon fire wirelessly with just the camera. Strobe should be set to s-ttl and the optical cap on the bottom of the strobe removed for wireless.

Does the Inon fire wirelessly with just the camera. Strobe should be set to s-ttl and the optical cap on the bottom of the strobe removed for wireless.

Hi am trigging my strobe by ikelite synk cord

if you do that you can not not have S-TTL mode

only Manual or auto mode

a don"t think a should removed the optical cap

but am not sure about that really

kent

Yes I agree. But to troubleshoot the problem, you can first see if the strobe will fire wirelessly. If it does, that will tell you the strobe is probably fine and you can begin troubleshooting your connections. I'd start with the hotshoe connection inside the housing and then the cord itself.

Yes I agree. But to troubleshoot the problem, you can first see if the strobe will fire wirelessly. If it does, that will tell you the strobe is probably fine and you can begin troubleshooting your connections. I'd start with the hotshoe connection inside the housing and then the cord itself.

HI

going to do that but a think thers is som problem on the cord have just notice som small

damage on the cord if that is the problem a don"t think my strobe is the problem it

working very good wht my old camera and housing as you say. The problem seems

to be on the cord or hotshoe connection but does the strobe fire whit out any synk cord

connection??????going to try out that suggestion

thanks for help

regards kent

HI

 

going to do that but a think thers is som problem on the cord have just notice som small

 

damage on the cord if that is the problem a don"t think my strobe is the problem it

working very good wht my old camera and housing as you say. The problem seems

 

to be on the cord or hotshoe connection but does the strobe fire whit out any synk cord

 

connection??????going to try out that suggestion

 

thanks for help

 

regards kent

I faced a similar problem with INON Z240 with Ikelite sync cable. Ensure that cable is properly connected to the strobe. Even though it looked perfectly hooked inside, the thick O-ring there seems to prevent a proper mate, unless you push it hard enough, before you tighten the outer cap.

Hope this helps!!

I faced a similar problem with INON Z240 with Ikelite sync cable. Ensure that cable is properly connected to the strobe. Even though it looked perfectly hooked inside, the thick O-ring there seems to prevent a proper mate, unless you push it hard enough, before you tighten the outer cap.

 

Hope this helps!!

hi my problem is solve the hotshooe contact was not properly install in the camera

but no everyting is working great

kent