Prolem with DS-50 and slave sensor. Not firing in sync!
Started by justin-branam ·
6Posts
6Replies
Read-only discussion
Prolem with DS-50 and slave sensor. Not firing in sync!
6 posts
Prolem with DS-50 and slave sensor. Not firing in sync!
I noticed in some of my night photos i had no light. i have the c5050 in an ike housing with the opaque piece in front of the flash, and i also have the ike ds-50 with the slave sensor. i did a test tonight, and it seems my strobe is not in sync with my camera's flash. here is a brief setup description. i have the redeye turned off (only one flash), and have the sensor set for no pre-flash. i tried setting the strobe on manual and on ttl in all of the following settings: p mode, shutter speed, and aperature mode. i tried setting the shutter speed from 1/1000 to 1/50 with no visible flash. the on-camera flash fired each time, and i also tried settin the flash mode on slave, and in+slave. no go on any of these settings. i am all out of ideas. any help would be appretiated. thanks.
I think you need the sensor set to yes pre-flash. This pre-flash has nothing to do with red-eye reduction. Turning off red-eye reduction does not stop the preflash. Most digital cameras use a preflash as a test to and then use the data obtained to then determine the strengh needed for the main flash.
I think you need the sensor set to yes pre-flash. This pre-flash has nothing to do with red-eye reduction. Turning off red-eye reduction does not stop the preflash. Most digital cameras use a preflash as a test to and then use the data obtained to then determine the strengh needed for the main flash.
tried switching the sensor to the pre-plash setting and went throught all the same settings again. still no sync. the strobe is firing, just not at the correct time? i guess i just need to buy a sync cord and a ds-125 for that matter.
Is strobe light showing in the photos? Initial guess is you don't realize how much shutter lag is present with these cameras. Peter Schulz has an enormous amount of instructions on following:
The setup you have should work fine. Are you using the TTL slave or the manual slave? Either way, reset the camera to fully automatic mode, regular flash, etc. Sensor should have pre-flash enabled. Use a dimmly lighted room and shoot a few pictures at 5-10 feet. It should work fine. Here are a few of Ike's help pages.