A question, maybe a silly one.

I was looking at the Nauticam N120 Canon Port Chart, specifically for the Canon EF 100 F2.8 macro. The table generally lists SMC/CMC and then (being FF) gives the working distances and magnifications for SMC-1 and 2. It seems like SMC-2 is much more powerful than SMC-1.

However, for the CMCs that I use, it's the opposite: the CMC-2 is less powerful than the CMC-1.

So, is it not possible to know the magnifications achievable with CMC-1 and 2 by looking at those for the SMC series?

P.S.

I'm using the EF 100 on a M43 system

The numbers following the dash in the model names reflect the chronological order of when the model was introduced so has NOTHING to do with magnification. Yes it should be possible to give a magnification factor but this is probably easier to do empirically as Chris did in the MFO-1 thread. The MFO-1 is more akin to a CMC than a SMC. I had been thinking of trying to use a CMC-2 with my 105 but now can trash the idea.

22 minutes ago, Tom Kline said:

The numbers following the dash in the model names reflect the chronological order of when the model was introduced so has NOTHING to do with magnification.

Okkkk now it's clear.

Thanks

The CMC-1 is slightly more powerful than the SMC-1 as I recall and the CMC-2 a bit less powerful. In previous versions of the port charts there were a few lenses listed with both SMC and CMC and you could see slightly more magnification with the CMC-1 compared to SMC-1.