Curved Glass Macro Port - Nikon 60mm n120

Hot off the printer:

17 hour print time!

Perfect off the printer! No post-processing or clean up was needed beyond brushing off some threads and dust.

Port, glass, glass o-ring, lock ring for glass, Ultima Dryglove lever or o-ring insertion:

Pushing in the o-ring: Quarters, then Eighths, then the rest.

Installed and Holding Vacuum:

Pool test later today.

Dive with empty, spare housing later this weekend.

Edited 2 hours ago2 hr by Dave_Hicks

Looks great. What is the diameter of the glass element? Did you take it from the EP PEN Dome?

That looks awesome

16 minutes ago, Atanas_Petrov said:

Looks great. What is the diameter of the glass element? Did you take it from the EP PEN Dome?

Yes. It was from a Zen Underwater WA-100 dome port for Olympus 9-18mm. Cost about $200 on ebay. The actual glass rim diameter was 103.85mm. I bought 103mm x 3mm 70a orings from McMaster Carr.

I got about 5 orings and used one up repeatedly using it to test fit and installation techniques in draft prints of the top of the port.

18 minutes ago, Atanas_Petrov said:

Looks great. What is the diameter of the glass element? Did you take it from the EP PEN Dome?

Really nice work. However, are you perhaps missing the feature that supports the port from being pushed back into the housing under pressure (circled in the image below)? If so, the port might only be supported by the plastic tabs of the locking mechanism (that's the case on my N100 housing).

20 minutes ago, Isaac Szabo said:

Really nice work. However, are you perhaps missing the feature that supports the port from being pushed back into the housing under pressure (circled in the image below)? If so, the port might only be supported by the plastic tabs of the locking mechanism (that's the case on my N100 housing).

Yes, that looks like a problem!

My extension ring design has that lip but i didn't (think) i needed that extra diameter for the port.

I will add that back into the design!